Reviewing the owners manual for my LZ200Z and noticed that Yamaha recommends use of the tilt-support lever when tilting up the motors. Do you use this to support the motors?
It further instructs: be sure to retract the trim rods completely during mooring. This protects the trim rods from marine growth and corrosion.
So I followed these instructions today and noticed that one trim rod does not fully retract. Anyone know cause?
Noticed that the tilt rod is total exposed...
Also, using the tilt-support lever, the lower end of the motor now sits in the water - is this a problem?
Thanks.
It further instructs: be sure to retract the trim rods completely during mooring. This protects the trim rods from marine growth and corrosion.
So I followed these instructions today and noticed that one trim rod does not fully retract. Anyone know cause?
Noticed that the tilt rod is total exposed...
Also, using the tilt-support lever, the lower end of the motor now sits in the water - is this a problem?
Thanks.