Latest activity
-
DThere is no f'ing way you are replacing them in the water. Prepare for pain.... Sorry...been there...
-
SkunkBoat replied to the thread 265 Express center rigger.I have a center rigger that clamps to the rod rack on the hardtop. The telescoping pole is removable from the mount. Slightly off center... -
-
DDennisG01 replied to the thread Scupper hoses.There's gotta be someone around with a trailer that you can borrow?
-
I had the dealership replace my scupper drain hoses on my 2007 Sailfish. Figured they had done it a time or two, which they had. They...
-
SkunkBoat replied to the thread Scupper hoses.There is no f'ing way you are replacing them in the water. Prepare for pain.... Sorry...been there...
-
SkunkBoat replied to the thread 12v question.OK understand what you have now. The DC stepdown makes sense. Not so sure that paralleling the TM bank ( the 12v you get from the...
-
DDennisG01 replied to the thread Scupper hoses.I think you're fine to replace it in the water - just have a "worst case" back-up plan. For example, if your plug should fail... what...
-
GGus_Ag replied to the thread boat seat swivel bushing.Thank you Seasick. I need the cylindrical plastic bushing only. I will try one of the local marine parts store. I removed the whole...
-
Ssling replied to the thread 330 Express: Rod Storage INSIDE cabin?.Hoe did you screw/bolt these in? There is a lot of weight with offshore trolling set-ups and I'm worried about them ripping out.
-
Ssling replied to the thread 330 Express: Rod Storage INSIDE cabin?.What did you use to screw these into the areas where the teak was? Just wood screws?
-
Hookup1 replied to the thread 265 Express center rigger.You need to get the center rigger line and fishing rod line up and out of the way 3 to 6 feet so you don't bang into it when handling... -
Mustang65fbk replied to the thread Hard Top Courtesy Lights - Freedom 285.Yep... that was the one that I linked above, it's by i2 Systems Lighting. -
DDiad replied to the thread 265 Express center rigger.Exactly! How do you handle the halyard on the center rigger? After release, you pull the clip back down, put your line in and send it...
-
Hookup1 replied to the thread 265 Express center rigger.! We run center riggers rod in the cockpit clipped up to the center rigger.
-
DDiad replied to the thread 265 Express center rigger.I’ll look into this but in my mind the halyard will be inside so it could interfere with grabbing the rod in the holder upon strike...
