257 Fisherman Windlass Wiring

K

Kbshaw11

Member
Joined
Jan 1, 2015
Messages
11
Reaction score
1
Points
3
I have a 2019 257 Fisherman. Does anyone know if Grady installs the wiring for a windlass from the factory even though the boat did not have it as an option?
 
You can look for a 10 Gauge pair of wires up there that go back to the fuse panel under the dash.
My 265 had them and I didn't have a winch.
They are for the solenoid, not for powering the winch itself. You need 6 gauge wire for that and a 70A breaker at the battery.
 
SkunkBoat said:
You can look for a 10 Gauge pair of wires up there that go back to the fuse panel under the dash.
My 265 had them and I didn't have a winch.
They are for the solenoid, not for powering the winch itself. You need 6 gauge wire for that and a 70A breaker at the battery.
Click to expand...
My 2017 257 was prewired.
 
seasick said:
Call Grady and ask.
Click to expand...
I did call this morning but the customer service person is on vacation until November 14. I will take a closer look when I am at the boat. I' hoping it has the wiring. The dealer thought it should.
 
I spoke with Carolyn at Grady and she said that the 6 guage wiring is included in the harness whether it has a factory windlass or not. She sent a picture of where they will be. They terminate at the helm. That is very good news!!
 
  • Like
Reactions: SkunkBoat
Kbshaw11 said:
I spoke with Carolyn at Grady and she said that the 6 guage wiring is included in the harness whether it has a factory windlass or not. She sent a picture of where they will be. They terminate at the helm. That is very good news!!
Click to expand...
Where do they originate? Are you prewired to the chain locker?
 
On my 255, the windlass harness was coiled up and ziptied inside the anchor locker. The other end was also coiled and found inside the console near the power block.
 
Rustygaff said:
On my 255, the windlass harness was coiled up and ziptied inside the anchor locker. The other end was also coiled and found inside the console near the power block.
Click to expand...
That would do as long as the accessory panel can handle the extra current draw.
 
I'll be at the boat this weekend and will take a look. Also, Grady sells the panel to replace the locker lid with the windlass mount panel and hardware. Around $1,000 though plus the windlass.
 
You must log in or register to reply here.