Recent content by '84_241_Offshore

Where in NH are you located?

Wish you were closer! I'm in NY on Long Island. A bit too far to trailer it home.

Just saw your post. Exactly what I was looking for. Your transom came out great! What was done at the edge of the transom where it meets the swim platform. Was the wood removed there also? The aluminum piece of my transom was screwed into the plywood on my transom, but it only went the width of...

Exactly! Im pretty sure that's exactly what happened to my transom.

Any other documentation? Thanks for what you shared so far. Think I'm going to remove the inside 3/4" plywood and replace with a pc of aluminum. 3/4"x4" and extend past where the plywood ends and tie into the stringers.

Take a look at this sketch. I'm trying to show what I'm describing that the plywood pcs are separate....under the aluminum angle in your pdf

That's exactly what I was looking for!! Thank you! Now..........do you have a print that shows a view looking at the transom? Including the aluminum angle that connects the stringers to the transom through the lifting rings? Looks to me like the (2) pcs of 3/4" plywood under the bang cap are...

Thanks for the reply(?). Are you familiar with the construction of the transom? Fiberglass skin/wood/aluminum/etc...... I'm trying to extend the life of my boat a few years. If you, or someone else can provide info re: the construction of the transom it would be appreciated. Want to make it...

The transom of my '95 268 has seen better days. Removed the twin engines, removed the Bang cap and fiberglass cap. Next I find a piece of aluminum the width of the engine well, ~60 inches in length, mounted on the top surface of the transom (~2") then bends down on the inside of the transom...

What I'm referring to is the fact that the hull/keel doesn't go all the way to the transom...that's what I meant by stepped hull.

No other options/interest?

I have a '95 268 Islander I am considering selling. Has twin '05 175 Evinrudes that run great, Lowrance GPS/Plotter w/ Radar, anchor windlass, 2 VHF Radios, raw water washdown and freshwater tank. Also comes with a trailer that has new tires and bearings. Factory hardtop. Running lights are...

Looks like a stepped hull to me,

I assume that's not your boat in the pic.

I wasn't expecting 22K......I'd take 10K