Recent content by Aquanut2

Have an 04 Marlin tried the A/C during the heat wave we’re having it was running, set to cold & pumping water but not putting out cold air. I know the unit is behind the fridge. Has anyone tried recharging it? Can I use the same coolant u can buy at an auto parts store? Thanks

I have a 300 marlin w similar problem my electronics would reboot when starting starboard mtr. As others have said house on all Gradys are definitely wired to starboard bank so yours must’ve been changed. I don’t know why grady has 4 batts wired in 2 parallel banks my solution was dedicating 1...

Hi @Boosted1 just curious which hatches you are repairing? I have a 2004 Marlin & wonder if it’s something I need to check.

2004

These guys install all the thrusters @ the GW factory https://www.floridabowthrusters.com/gallery/nggallery/page/1

Speaking as a huge GW fan owning several GW offshore boats If fishing is your priority on inshore and want to chase reds in shallow waters the CEX has too much draft, too many creature comforts & not enough fishing features for me. Small livewell under seat imagine the mess putting a castnet of...

My 2004 300 Marlin have to Trim the Starboard tab down 2-3 I believe it is the 4 batteries under the back Port box

Winterville Machine Works makes them for GW they have all the templates way back when they shipped me a top for may new 90 232 Gulfstream in 92

Instead of paying $40 for a new back up sender you can use a 240 ohm resistor for a few cents which is what a sender reads when tank is empty. Conversly it will read full at 30 ohms and ½ a tank at aprox 135 ohms. I used a resistor to determine the tank numers pin outs on my CL5 as cables were...

Hi there I ended up getting the smeta .7 cf microwave from amazon for $75. Had to cut a new starboard front face and foot holding board for the base but it fit fine and the cord was long enough. Amazon doesn’t list it anymore but can be found elsewhere...

Just to follow up the GW pn is 10-152 Taylor marine in DE has them on eBay for $27 ea their prices are a rip off so I ordered from my local Radio Island dealer for $6. Couldn't find the OEM part there are knock offs on amazon but harder plastic and not as tall

Hi @RobboNJ looking for the same clip mine broke while cleaning up after a fishing trip yesterday. Could you share that link? ty Mike

there is also a yellow wire inline fuse in the gauge cluster that could be dirty/blown I had a short in the CL+ bus that blew this fuse. gauge wouldn't come on but motor ran

Had a 90’s 23 w an outdrive and a 250 SW series 2 banger. With the wider beam boat was sluggish when in rough seas 4-6’ it was hard to stay on top w one motor. my advise would be to go w twins. Also don’t expect ti have any control w a single screw in reverse on a bracket.

I ended up buying these which I understand are the current year model seats. again no GW logo but almost $2k cheaper ea than what a GW dealer will sell them for w the logo. https://www.llebroc.com/product-p/4bmk3001.htm