Recent content by bayson

Well NO water in the full filter, thank goodness, so there has to be another problem why she won't go over 4000 rpms.

Sounds like it could be the vent hose or cracked filler. Only found a small amount of fuel in the bilge when 1st filled, none since. Smell of gas in the cabin just after fueling. Would the water leak into the fuel from the vent hose? 2005 23' Grady w/2020 300 Suzuki. This boat was kept in a...

Appears I have the problem again. I am wondering if I have a bad tank? When I filled up last I noticed a little gas in the bilge, then nothing after. Now the engine is running at under 4k rpms. 300 Suzuki with 75 hours. The boat stays on a lift.

I'm having the Kleenfuel guy come take care of the problem.

'05 Gulfstream that I have water in my gas. I have a quarter of a tank in my rear 100 gal. tank and just filled my 50 gal. tank. I was flipping back and forth between tanks so not sure where the water is coming from. HEAT was recommended to remove the water. Will this work? If not what to use?

The motor weigh is not much different between the 225 and 300, but much more power. Going to be a great boating year on the Chesapeake Bay!

The bracket is in good shape. Having it sandblasted, pretreat and painted. It will be better than new. The problem was it wasn't sealed by Grady, just sealed around the bolts and caulked on the outside. I was wondering about foam filling the inside?

No luck. Called Armstrong and they said at least 7 month delivery. Ugh

I have an '05 Gulfstream that I'm replacing my 225 Yamaha with a new 300 Suzuki. I noticed some peeling on the bracket and thought it was painted. Got a call that there was water inside the bracket. This is a Gill bracket put on by Grady when new from the factory. The shop said they will take it...

As with the world they are closed to next week. Then I will check with them. Thanks

Getting ready to repower my '05 with a new 300 Suzuki. At his time I only have a small side platform. Looking for suggestions on where to find a full length platform.

The seagulls have discovered my dock. Covered with , you know. Any suggestions?

Got my new enclosure. Now what is best for maintaining all like new?

The Dremel did the trick. I wonder has anyone replaced the front and side enclosure with something more permanent?

I would like to use the old enclosure for the pattern. Is there a problem doing this? Dremel might work.