Recent content by DSC

2008 GW 360 Express with twin Yamaha 350s, about 800 hours. New Fisher Panda Generator, New twin Raymarine Axiom displays, new upholstery, full cockpit enclosure. Everything on the boat is fully functional. $220,000. Located near Atlanta.

oil change, fuel filter change, lower unit gear oil.

2008 360 Express with 350 Yamahas (700 hours). Boat just had its 100 hour service and on the first run after service, the starboard motor began losing RPMs at higher rpms (4800). It was dropping into the low 4000's and upper 3000s. Lower RMS ran fine. Port engine was fine. . Never had this...

Storage for the inflatable is definitely a problem, but I second the torqeedo. It is light weight, breaks down into smallish easy to store pieces, that can lay flat. Not super powerful, but better than rowing. I bought a spare battery for mine which between the two will give a nice range.

Sink/shower drain overboard. Holding tank is for the head.

I didn’t know there was such a thing as an overflow vent for the head. When my tank is full it backs up into the head itself.

Thanks so much. Ordered the part. Much appreciated!!

C, I just had the same thing happen to mine. Did you ever figure out the cause or fix?

Twin 350’s

Hello, My Fischer Panda gen isn’t turning over and I’ve noticed that I don’t hear the fuel pump ticking away prior to starting. I’m thinking it’s a bad pump so I was going to attempt to change it. I’ve purchased a similar pump....any tips or anything I need to be especially concerned with? Thanks.

That was my thinking too.

I have an 08 360 express with the same exact problem. Gen works fine unless on a plane in which it overheats after about 10 minutes. Mine is in freshwater, flat conditions still cause overheating when on a plane. I’ve had it serviced and still can’t find the problem.

Thanks for the info. Much appreciated.

Anyone pull a tube with a 33 or 36 express? If so, did you use the stern eyes? Thanks.

Is there a way or some type of connector to connect a newer model Lewmar bow thruster joystick (8 wires) to the existing 4 wire (red, black, blue and grey) supply from the thruster box?