Recent content by wbdenamur

Do you remember how much $

Does anyone know where to get a replacement refrigerator for a Grady Marlin 2003?

Where can I find a 12 inch tie rod to connect my Yamaha f250s on a Grady Marlin? Mine rusted and broke

I have the 6 inch Beckson pry out deck plates. I ordered the DP6 o ring from Partsvu. It was a Beckson product. The o ring is about 1/4 the thickness of mine. Where can I get a thick one?

I actually thought about using the plastic but thought it would get brittle and crack over time.

Would you recommend using 4200 or 5200 when replacing the brass motor well drain tube?

This black box mounted on the front of the 5e is what I’m referring to. You can start and stop it from there.

I have tried running water in the deck drains and there was no accumulation in the bilge. I haven’t checked the anchor locker. I will. I also had a bow thruster installed and will check around it as well.

Which electronic box do you need? The one on the front of the generator?

Probably a Koehler 5e gas like I have in my 2003 Marlin. I’m removing mine and disposing of it because of the constant problems.

I had 2003 F225s on my Marlin. I dropped both lower units and scoped the exhaust tube. Both had corrosion. My marina replaced both with a kit from Sim Yamaha. One engine had beginning of corrosion on the bottom of the oil pan. It was cleaned, repaired with a weld and checked a year later. All...

I believe they are worn and leak water into the bilge.

I I have a 2003 Grady Marlin 300. These are the pop in plates, not screw type. The diameter of the opening is about 7 1/8 to accommodate the plate. It is original Grady equipment.

Does anyone know where to obtain a new o ring for the round access plates. My o ring diameter measured at 7 1/8 inches.