Search results

Scrolling through on rainy day and saw pics. Have same boat. Can you tell me about the lettering? What is the script, what is the overall length of the name and size of letters, about how much did it cost and who did the work?Sorry for all the questions!!

I have the 228g grady which is the bracket mounted outboard motor. Does transom mounting in centerline near drain plug pick up turbulance/air bubbles from prop?

Megabyte, did you mount the transom mount transducer near the center drain plug? Mine is a 500watt mounted more to the outside but I lose pic at speed > 20mph unless I tilt transducer up a little bit> So is it better to mount transom mounted transd. more in center line of boat?

has anyone replaced the aluminum trim piece that runs between the non skid deck and the walkaround step next to the cuddy cabin on a 1987 22 seafarer ? It is about a 1/2 "wide and is pop riveted into the fiberglass. Is it tucked under the deck or can you pull it out and replace it?Mine is...

I pulled up and cleaned off both lids. Used one cartridge. Dont forget to lay in mono fishing line before caulking in case you need to redo

pulled up old stuff and redid it. The new caulk is much better. Must have been a bad tube.thanks for the information.

I sealed fuel tank deck lid with white GE silicone II tub and bath caulk. The problem is the caulk is still tackey after a week. What is the problem? Can I use 3M clear silicone marine sealant if I decide to redo? It seems easier to work with

Izzy, do you have pics? Did you use vinyl and how did you apply?

want to tear out old carpet inside 228g cuddy. anyone have experience/pics with painting inside cuddy. any advice as to surface prep, type of paint to use, brush vs roller,how to hide wires? if paint is not a good choice, what can you use?

The 2' by 4' fiberglass cockpit panel that covers fuel tank is spongy around the plastic access hatch. I have removed the panel and the wooden squares are soft. I plan to chisel it down to fiberglass . Can someone walk me thru the next steps to repair? It looks like I need to use 3/4" marine...

beagleboy (john h) 1987 228g no motor-still looking