Search results

Fine tooth blade on both table saw and jig saw

Yes black 1/4 inch starboard

Just finished mine on a 2000 Marlin

I am moving up to a Marlin and need to sell my 2005 GW Release, asking $69,000 - very well maintained located in South Jersey. This is a well built fishing machine - 2x Yamaha 250HP ~1705 hrs, professionally maintained - Garmin 8616xsv with Radar, side scan and down sonar - Sitex autopilot -...

I have an older Samsung tablet that might work well for this

I have a Garmin 8612 MFD at the helm of my 2000 Marlin. I believe this unit is Wi-Fi capable, has anyone used a Wi-Fi capable screen to see the sonar down closer to the fishing area on the boat? Is there a less expensive alternative to a separate networked unit?

Thanks I agree no short cuts

Thanks Frank. I’m having the gel coat redone in a light blue a little lighter than you did

I have an unpainted 2000 Marlin that will finally get bottom paint. How important is it to apply a barrier coat like Interlux prior to bottom paint?

I have the same problem. Supply line is broken somewhere in the headliner. I think I will just close it off , not worth the effort to remove the liner to replace it

Yes, Sean and I store his Parker with you

They are all chrome plated brass or bronze. Generally pitted. Watch a bitch removing them but will look nice with new stainless fittings

I am replacing all the thru hull fitting last on my 2000 Marlin after having the gel coat redone. Do the old fittings have any value or should I just toss them?

I have a 283. It is a solid rocket. Great boat. I also just bought a 2000 Marlin with the intent of flipping the motors to my 283. I am now seriously considering keeping the Marlin for all the reasons stated above. I run the 283 to the Wilmington on occasion but it cuts the 1/3 rule close...

Deck lights

Just found that the 761 uses a metal fleming

Seasick thanks but maybe I wasn’t clear the picture in the manual for the 761 Gypsy does not show a Fleming in place does that particular gypsy not use one?

This is a serious question

Here is a tough one I hope can be answered. I have a 2000 Marlin. I believe the windlass is an original H 600ff. The motor seems to work properly in both directions the gypsy is labeled 761 but there is no Fleming. Is the Fleming required on this model.? It doesn’t seem to catch when...

My level sensor on my Groco system is bad. Is anyone aware of a cost effective replacement?