Search results

thinking of upgrading from 2005 four stroke 250, to a 300 as the newer models maxed out at .My 226 is equipped with hardtop, 9.9 aux , and to much gear !! it performs well with the 250 but feel it maybe better with a 300 . Has anyone done this , little bit of inner transom structural upgrade to...

I am purchasing an auto pilot for my Yamaha 250hp/9.9 high thrust for my 2006 228. location is my biggest issue, currently have 2 helms , original up front and the second at the stern .where are most locating there pumps ?? any ideas or pics would be greatly appreciated

want to clean my plastic windows , what product do you use or recommend

was installing new transducer wire back to the helm, pulled off the bulk head cover and it literally crumbled and fell apart , no caulking between floor and removable bulk head cover , any one else had this problem, take very good care of my boat, was a bit disappointed when I found it, looks...

Installing a through hull in my 2006 228 in the bilge area, have to drill a 3 3/4 in hole , my question is im assuming that area is solid fiberglass and use 5200 or 4200 for bedding compound. 5200 is better for under water applications but im worried if I ever have to remove .

Have been having trouble with the plastic locks , have tried lubrication, when I put key in and turn it removes the core, what are people using for replacements

Thinking of installing this heater in my 2006 228 Has any one tried , looking for location ideas

what to install a through hull transducer , is there enough room in the bilge area ?? any one have any pics of the install. I have two tanks so that area of the boat has no room , any ideas ???

my horn just stopped working, can see positive leave switch and I assume there is a pos/neg that is soldered to each horn, has any one had this type of failure before there has to be a connection some where I cant get at or find

couple of my locks don't seem to be functioning im sure the cuddy and bin locks were the same key, maybe need some lube

I want to install a through hull transducer in the bilge area, has any one done this , im trying to remember if there is room , would any body have any pictures

Looking for ideas how people have mounted there Electronics, Iv got a 2006 228. Looking at possibly mounting a Garmin 7610 in upper electronics box and may be a 8 inch version at the helm, any or all ideas would be great

why cant I post pictures from my desk top

I do a lot of anchoring in fairly deep water, with an average 250 feet and use the Scotchman retrieve system. Have been looking at the 232 Gulf streams pulpit roller the chute type which carries a Bruce anchor perfectly. Looking for some measurements and pictures to all you 232 owners. Is the...

Having a couple of lock issues on my 2006 228 Grady. One of the electronics and one of the cuddy locks wont work , kind of gave me issues from day one. Has any one used a spray to help or assist in operation

installing a radar dome on my 2006 228 hardtop , looking for mounting ideas , mount directly on hardtop, dome pedestal, small radar arch, send some pic if you can. look forward to seeing your set up

im looking to install a GARMIN 1042 GPS (12.5 X 7.3) IN THE ELECTRONICS box behind the steering wheel. has any one got something bigger than a 9 inch gps in this location, it looks tight

Going to treat my clear windows of my enclosure with IMAR , they say to clean first with a non detergent soap , what is everybody using for soap , NOT so easy to find. any help or suggestions would be great

getting close to freezing and want to drain the fresh water out of my holding tank , is it just a matter of opening a valve and draining , I will start looking to see if it is obvious.

The block fuse beside the switch is open circuit/faulty is it resettable or is a replacement fuse required or do I need a new block