Search results

what is vst tank?

thanks. I will look at that.

I have a 2005 Suzi 250 4 stroke that I recently bought. Before running, I replaced the old Sierra filter with a Yami 10 micron filter and replaced the other fuel filter as well. The old filters had some water in them. I also drained the fuel tank of any remaining gas(approx 15 gallons) and...

There is only one pump w/ a divertor valve.The baitwell has worked previously but the washdown side has never worked. Now the baitwell will not fill up. How can I test without putting boat into water?

I am not getting water into the transom livewell. It started to fill up yesterday (approx 1 qt) but shut down after. I have a raw water pickup strainer on the bottom of the boat, the cutoff valve is open, and a new Baitmaster pump inside the cuddy cabin. When I flip the toggle,I can here the...

thanks for input. Those things are expensive!!

Correction. The pump is a Shurflo Pro Baitmaster. I wired the pump directly to battery.Pump did not turn on or hum . I guess it is needing replacement. What is best pump to use in a dual operation?

I have a Shurflo Problaster pump that functions in both capacities through a Y valve at the stern. When I switch it over to washdown the fuse blows on the switch panel. If I operate in the baitwell mode it does fine. Today the pump wouldnt work in either capacity When I flip up the toggle...

would the wise slider fit original helm seats on 1987 228g? how far apart are the slider hole patterns from side to side and front to back?

The first thing they did was rough up the bed of the truck with a grinder then I believe it was sprayed on. I was pretty nervous about a grinder in a new truck but it worked out really well. The color was a dark blue to match truck so it was an extra charge but not too bad. There are a lot of...

in the truck bed iused to spray it down with house . very cleanable and no mildew.

how about that spray on truck bedliner ? It is a hard rubberlike substance that really wears well and didnt crack while on my truck.

i get about 2.5 to 2.7mpg using a 2003 200yami OX66 on my 1987 228g. optimum conditions and trim

I have a 1987 228g grady I repowered last summer. Found a new Yamaha 2003 200hp OX66 stored at a boat dealers shop. Paid 8k delivered to Houston. Engine came with 2yr factory warranty. Took 6 mo of looking but there is some good stuff out there.

Thanks for input. Will try finesse first wet sand later

How and what do you use to wet sand a boat? I want to remove some swirl marks, scrathes, and dull areas on the cuddy cabin

beagleboy john 1987 228g 2003 200 yamaha 0x66

i have 1987 228g and pump is in cabin on starboard side down inside the storage area

I was told by service guy at marine max to try and tip transducer nose up a little bit to get a better pic at wot. I tried it and it did improve pic. It may make depth reading not quite as accurate but not by much

How hard is it to replace the 2 piece rub rail on 228g Grady?Any tricks or idaes on making job easier. I was told the insert is difficult to fit unless it is warmed to make it more pliable