Search results

I have a 326 canyon and want to replace the cup holders with cup/rod holders. Does anyone have experience with this task?

Looking for opinions on weather an open array radar on a 6" mount, would be any better than just mounting it on the hardtop. It's going on a 326 Canyon.

Now that you mention it I do recall there being a support. I'll look in the garage. I'm sure I have that also.

Pre-commissioning sale price of $65,000. After boat is detailed, bottom painted and all commissioning maintenance is done the price will be $75,000. Boat has all Simrad electronics NSS eveo3 12 2021/ chirp thruhull transducer and side scan transducer, NSS 9, NSE 12 , AP28 auto pilot , Uniden...

It needs a cleaning but there is no cracking or cuts

Look at the marlin that is for sale here. Is the seating configuration on that boat what you have or want? I may have misunderstood what you're looking for. I have the other kind of seat a stationary seat not a swivel seat like the one shown. I will take a pic tomorrow .

I have one off my sailfish. If you're interested, I can send you a picture.

I have a 2006 282 with twin 2006 F250s aprox. 1170 hrs. All Simrad electronics. NSS evo 3 12', NSS 9 touch screen, New through hull chirp transducer, and side scan transducer. NSE 10", AP28 autopilot, 3G radar. All systems work. Full enclosure. Engines maintained by a certified Yamaha mechanic...

Any interest in a 06 Sailfish 282

Hi, I'm interested How many hrs. on the engines? what is the asking price? Do you have maintenance records?

I have a 2006 282 Sailfish for sale. Twin Yamaha f250. I'm looking to upgrade to a Marlin 300 because I do a lot of trips to the Hudson Canyon and would like a larger boat.

I have a 06 282 and installed the b175 hw midship under the lower bunk I also installed the active image transducer on the transom next to the drain plug

Great job Capt I just had the same transducer installed on my 06 282 I had them put it in the mid section of the boat under the lower bunk. I have it connected to a nss 12 evo3 cant wait yo get out there and test it out. have a great boating season.

As an aside... my friend put a rubber based product from home depot in his basement. not a glue down product and it clicks together like those laminate floors. it looks great for a basement maybe it would work for your need...easy to replace if need be

Thank you all for your input. Your replies are a great help. I will get the info off the bad one and order a new one this week.

The lid on my 06 Sailfish doesn't stay open anymore. Anyone have an answer? Looks like it might be the shock absorber that might be bad?

I had the same problem with my dome lights. Needed to replace the switches. Mine were held up with just 2 screws in the base of the light. I took the lens off and the 2 screws inside. Yours might be held on with some calking.

I use a 25' pocket hose with plastic ends. Didn't want the brass because if I drop it on the deck I was afraid of chipping the gel coat. The plastic one works great. Use a 50' er for washing the boat and flushing the engines. One note though. I use to leave the hose on the dock, hanging on the...

Thx for the input. I did find the problem. Bad switches...I bought new ones and that fixed the problem.

I have 2 cabin lights not working. Bulbs are good. I tested the socket with a volt meter and read 12 volts. The lights in the head and spot light over the bunk both work. Has anyone run into this problem?