Search results

After striking out in the Search department, I will ask: My friend has an Evinrude 150 , e tec ,two cycle motor. He hasn't used it here in Florida for about 6 months. Upon successful start up the "check engine" light immediately came on. All oil levels were checked prior to start up. Any...

I have a 1995 Yamaha 200hp,2 cycle outboard on my 95 , 223 Tournament. I have found a used Yamaha prop for sale. It is a Right hand, 15 3/4" x 13 degree pitch ,Saltwater Series II, SDS. Could this prop be compatible with my motor? Please comment. Thanks

Good morning, I am considering installing Hydro Turf decking on my 95 , 223 Tournament. I am looking for feedback regarding longevity, ease of install etc. Thanks in advance, Capt 1947

I am thinking of putting a bimini to shade the forward vee seating area of my 95, 223 Tournament. I would appreciate any first hand feedback/picture of the install and practicality of same. I do have a standard bimini for the cockpit. Thanks, capt1947

Good morning, I am currently in the market for a used trailer for my 223 Tournament. I would appreciate suggestions as to the most compatible trailer, ie: easy loader, float on, magic tilt, etc. for my 95 Grady. As I said, a gently used trailer. Will most likely get used 3 times a year for...

Thank you all for your comments and input. My truck prior to retirement was an F-350. No problem towing anything. I have now downsized to a 2019 Nissan Frontier SV, six cylinder, two wheel drive. My concern lies with the ramp angle and traction.

Does anyone in the forum have any first hand experience with trailering a 22 Tournament on a tandem trailer, pulled by a late model Nissan Frontier, six cylinder,two wheel drive. My concern lies with the truck's ability to pull the boat , up a typical, paved boat ramp. Level ground should not...

If you look for a thread of 8.26.19 by fellow member, "seasick", regarding seat slides. Please see my reply. I ended up making my own from "Azek" trim material. I didn't take photos...sorry. Good luck,

I would like to install an aft cockpit bimini top and frame on my 223. I would like to incorporate this new top so it zips and joins the trailing edge of my existing bimini top. My question is: does anyone have this arrangement and if so is it custom or is there a company out there that has...

I regret not taking some photos of the substitute slides for my seat. I can tell you that if you use a small tap ( 8-32 ) for the aluminum frame and use fh machine screws ,countersunk so as not to rub on the seat frame, you should be fine. I used three screws for each side of the seat. Make...

Hi Seasick, I had the same problem with the seats on my 95 Tournament 225. I ended up making my slides. I removed the sliding seat from the boat and worked on the bench. I took a piece of 3/4" Azek Trimboard, ran it through my tablesaw, fashioned it to the correct length and thickness...

I am looking for replacement O Ring gaskets for the inspection plates in my Grady Tournament. Any help on where to get them is appreciated. Thanks Capt 1947

I have a 95 Tournament 223 with the pomp. ladder back helm seats. I am looking for a reasonable parts source for the fittings, operators etc for the units. Thanks, capt1947

Hi, I am hoping to get some information regarding replacement parts for my helm seat. I have the upgraded synthetic, ladder back , arms ,swivel, sliding seat . I think this was originally by Pompanette. Is there anywhere I can get bushings, slides etc. in SW Florida? Any help is appreciated...

Hello , I am experiencing theft of fuel . My Grady is a 95 Tournament 22'. I have not been able to find a "factory" fuel fill insert to try to prevent more theft. I really don't want to install a hasp and lock, unless I have no other option. I believe the filler neck fitting is a Perko...

Hi, I have the need for a locking gas cap for my 95 223 Tournament. Several of my marina neighbors have been hit in the last few weeks. Any suggestions based on experience and use will be appreciated. Thanks, capt1947

Hello, I am begining the research process regarding the addition of a "get me home" outboard for my Tournament. I have the standard notched transom with a platform and boarding ladder on the port side. I am looking for info for the type of bracket, long shaft or short, lift vertically or tip...

I have a 95 223 Tournament with a 200 Yamaha. I fish this boat here in SW Florida and also use it for family outings. I have found that the cockpit space is more than adequate and the bow seating is very accommodating. I couldn't be happier with the versatility offered by this model. I do...

Hi, My helm seat ( upgraded ladder back,with arms type) has lost much of the plastic guides that insure the seat slides without wiggle or metal to metal friction. Does anyone in the forum know where I can get some replacement parts for this? Thanks in advance

Hi folks, I wish to thank "Seasick" for his continued pragmatic approach to solving my electrical starting problem. As indicated in my previous post, I would follow his suggestions and let you know. Well he was right on the money. My problem was in the negative grounding all of the time. I...