Search results

  1. H

    2002 192 Tournament Wiper Motor

    I just completed a complete rewire of my 2002 192 Tournament. In the process, I learned that the wiper motor is bad and need a replacement. I’ve tried searching but can’t find a thread specific to this model. Does anyone have a replacement part number? Many thanks.
  2. H

    2000 Grady 192 for 1st boat in PNW?

    I have an ‘02 192 with an ‘02 OX66 SWSII. It is a great boat. You can get a snap on cover for just the front and with that and the windshield closed, it provides a pretty good degree of protection on cool days. You can likely get an isenglass enclosure that will snap to the windshield from the...
  3. H

    Wiring off the battery terminals

    If it were mine, I’d have it set up as follows: bilge pump directly to the battery with an in-line fuse, if you anticipate keeping it in the water. If not, this isn’t as big an issue. Feed for house panel directly from battery to circuit breaker of appropriate size. Mine is a 60 amp circuit...
  4. H

    2002 Tournament 192- Largest Fishfinder in box

    Just an FYI, I installed a Simrad Go9 XSE today in the driver glove box of my 192 Tournament. It is extremely tight, definitely the max that you could fit in the box. In fact it is so tight that you cannot put the cover on the unit when it is installed. I typically remove my electronics between...
  5. H

    2002 192 Tournament wiring

    I am working on rewiring a Tournament 192. Mine is a 2002. Does anyone have a source for the switches are breakers that were used? Also, does anyone know what type of connectors were used to terminate the panel harness? Many thanks.
  6. H

    192 Tournament wiring question

    I have undertaken running new wiring in my 2001 192 Tournament. The factory wiring is a mess. does anyone know whether there is a bus bar for grounding in the bilge? I can’t seem to locate one and all of the wiring in the bilge is a complete rats nest.
  7. H

    Sending Unit for Tournament 192

    Thanks! Customer service was very helpful. For future reference, the 2002 192 Tournament takes a 9 inch Wema Sending Unit, Wema part number sss-9 151330-9
  8. H

    Sending Unit for Tournament 192

    I need to replace the fuel sending unit on my 2002 192 Tournament. I am going to go with a Wema sending unit. Has anyone replaced theirs on a 192 Tournament and if so, can you tell me the correct length or a part number? Many thanks.
  9. H

    Tournament 192 replacement windshield

    I had the kids in the boat with me and a storm blew up pretty suddenly. I got back to the dock and tied up and took the kids to the truck. The tube (three seater-weighs about 50 lbs dry and it was soaking wet) was in the cockpit laying pretty flat, but a gust of wind maybe 60-70mph picked up the...
  10. H

    Tournament 192 replacement windshield

    I got caught in a wind storm today and a flying tow tube ripped off my starboard windshield. Does anyone know offhand whether the freedom 192 windshield will fit a 2002 192 Tournament? I’m sure this will cost an arm and a leg and so alternatively, has anyone found anything after market that...
  11. H

    Picture of VHF Antenna Mounting on 07 Tournament 205 Needed

    Mine is about a foot forward of this one. Drill through the vertical surface just below where the forward most portion of the window frame and put a clamshell over once you’ve run the coax into the console. You can then either drill another whole into the glove box, or mount a black box type vhf...
  12. H

    MFD on 192 Tournament

    I am looking to place a 7 inch MFD on my 2000 192 Tournament. Has anyone completed a similar install? Console space is limited on this model and I’m struggling to find the right spot. I wish it did not have the glove box or instead had a taller box/mounting surface in its place.
  13. H

    Bilge pump thruhull 2000 tournament

    Does anyone have a replacement part number for a the through hulls used on the early 2000s Tournaments? Mine are showing their age and I’d like to replace. Thanks!
  14. H

    Question about scuppers 2002 192 Tournament

    I am going to buy the ones like yours or the ping pong style ones. Just trying to figure out if the setup was factory or something added by the guy I purchased from.
  15. H

    Question about scuppers 2002 192 Tournament

    S The top gasket was against the outside of the transom followed by the second, then the third with the flapper, and all secured by the retaining ring. Would this be a normal installation on a 2002 192 Tournament? Seems pretty shoddy to me. Was it normal for the through hills themselves, not...
  16. H

    Question about scuppers 2002 192 Tournament

    Mine have a white retaining ring, with three layers of black rubber gaskets beneath. There is no screw in the flap. It appears that the first rubber gasket seals around the outlet of the brass drain tube. The second appears to be what the flapper seals against, and the third is the gasket with...
  17. H

    Question about scuppers 2002 192 Tournament

    Does anyone know what size tubing works best for replacing the tubes themselves?
  18. H

    Question about scuppers 2002 192 Tournament

    This is a white plastic ring that is screwed into the transom on the outside with a rubber flapper. It is not connected to the tube through the transom, which appears to be a brass tube similar to what Whaler used on their smaller boats for many years. I really hate these tubes as they don’t...
  19. H

    Question about scuppers 2002 192 Tournament

    I was inspecting qthe Through hills for my scuppers today. They appear to be brass tubes. On the outside, there is a ring that screws into the transom, with a rubber flap. Was this typical of the 2002 era Tournament? The tubes appear to need replacing, and the flapper is dry rotted and will need...