Search results

86 tournament 225. Connects the bow anchor locker to the port floor drain. Im hoping i can re use the tee because I cant find them online.

I'm replacing the hoses on my old teleflex steering. One end is the same and the new seastar hose. The end the goes to the copper is different. Its larger and goes to a flared union. Has anyone ran into this?

is there wood in the entire hull or just the transom. 1986. I want to install some new through hulls. Curious if its just fiberglass on the bottom and where the existing factory fittings are.

I have a no spark Issue on a 1991 225 txrp. Stator and pulsar ohm out good. The manual gives a chart to test the cdi and it doesn't make any sense. If i unplug the yellow bypass wire it starts rightup. Plug it in it stalls. Occasionally it will start with the system normal. I had it running...

I came across this. Has anyone done this or have info? Right now the assigned anchor locker is in the floor which is super inconvenient. Id like to add a roller too.

I could buy a brand new set for 200 . The say 17-20 foot. I have a tournament 225. Would they be sufficient? Thanks

I have an 86 225g tournament. We like the boat. Its solid, needs some tlc. It has a 1991 txrp. Im nervous about the longevity of the engine. The boat isn't the ideal boat for my family but I can see keeping for a few years. I already put a new fuel tank in it too. What would you guys do, pros...

my boat doesnt have one. Port side seat has an aerator in the right side compartment. Was the oval tank under the cutting board in the stern supposed to be one? Is there a preferred method of adding one? Thanks!

What would you guys use? Treated, standard, pvc?

UPDATE: tonight I layed in one layer of 1.5 oz csm. I coated the core, marine ply with resin and let it sit for about 45 minutes. Then I made some peanutbutter and troweled it onto the core than layed it in place. I probably couldve used like another 3 oz of resin to wet out the csm. Tomorrow...

Hi all, I really appreciate the help ive been receiving from you all. Hope i can contribute something soon. Anyhow, what does this label mean and what is this ground stud ? My tank had now ground wire on it and I figure it should. Does it go back to this? Is that supposed to go back to the...

Would this be good to 5200 to the bottom of the tank. I would cut square to fit the proper areas. Are there other better or cheaper options?https://www.mcmaster.com/neoprene-rubber-strips/high-strength-fabric-reinforced-multipurpose-neoprene-rubber-sheets/

I just bought a 1986 225 tournament. I suspected it needed a fuel tank. Well it does. I have both panels off. The rear hold has a fill and vent hose in it. Anyone know how they are routed? The tank is in the front hold. Also, i was thinking of converting the rear hold to an insulated...