Search results

On my 94 Sailfish, I've got three batteries (one house, one for each of the two engines). Each of the engines will start and trim as long as its switch is pointed to "1" or "both." However, if I turn either engine switch to "2" -- although the gauge lights display and the initial three beeps...

Any suggestions how to run my frige on shore power? There is an AC outlet near it on my 94 Sailfish. Maybe I can tap into it with a converter of some type. Obviously, I would still want battery power to it when on the water. I could probably accomplish this by using a converter in conjunction...

On the starboard engine of my 94 Sailfish, the 2-cycle oil reservoir hit the low level. The alarm sounded as it should. However, I couldn't pump oil into it using the emergency switch on the rear of the engine. I'm going to assume it's the pump in the main oil tank unless anyone has a better...

I'll claim to be the dummy. :wink: Please feel free to correct/sharpen my operational understanding of the manual head in my boat. 1. Use the head. 2. On the seacock just starboard of the keel under the cabin floor, lift the valve handle to the vertical position. (The seacock just port of...

My trim indicators for both engines always display figure A no matter what position they're in. Any ideas? Figure A 5 4 3 2 1 ██ (This is a black box for those of you whose computers may not show these ASCII characters)

I have this unit and the LCD seems "bleached out" in the middle leaving only about 1/2" of readable info on the borders. Any ideas 1) how to repair this or 2) where I can get another LCD for this unit? Thx.

On the water recently, my port engine's rpm limiter kicked in (in other words, it ran hot). However, the gauge did not signal an overheat nor did it give the beep warning. Where should I begin to track this down? Is there a way to manually send a signal to the gauge just to check the arrow and...

I'd like to add these to my 94 Sailfish. Engines are 94 Yamahas. Recommendations?

Where can I find these for my 94 Sailfish?

Just bought this 94 Sailfish and the enclosures have been in storage long enough for the zippers to be stuck. I've tried various lubricants but can't get them unstuck. Any ideas? What about where to get replacement covers if I decide to go that route?