Search results

for my suzuki df300, Been using biobar eb , I feel it does a good job preventing corrosion, also does a lot more and I use this throughout the season with ring free + you can google biobar eb and corrosion , theres some nice tests that were done.

when I first had my df-300 installed,the prop they originally sent was the 3x16x18.5 , and that was just too much of a pitch for our setup. The motor at wide open throttle was supposed to be near 6200 rpm , and we were way below that. they were nice enough to swap the props for us to the...

is it a dual mini ? I got 5 years out of this one, the "All Stainless" Version http://www.yachtsupplydepot.com/safety/ ... 20050.html

Re: ProMariner ProSport 20 Generation 3 20 Amp, 12/24 Volt, been very happy with the dualpro {pro line} , got it here, http://www.chargingchargers.com/marine- ... /pro2.html I can't say enough about how well this charger has worked so far, installed it over 5 years ago and hooked it up...

billfish33 Bill '93 Gulfstream 230 {notched transom} single 2009 Suzuki df300 {30"}

Both the washdown and bait sentry pumps run without restriction. I'm going to add a standoff bracket from the bait-sentry to the sidewall for piece of mind. I've had it like this for 2 seasons without any problems,but it really should have a bracket on it !

Robert, I did away with thay Y-Valve , I couldn't run both at the same time with the old setup. I use a shurflo bait sentry livewell pump , http://www.shurflo.com/marine-products/ ... fault.html that's the white pump that's attached to the seacock, that pump has a pass-through that I connected...

I bought a Dual Pro {Pro-series} 2 bank 3 years ago from charging chargers and it's been flawless,the Pro series is 15 amp per bank. It's also fully waterproof.

Well, I finally got around to replacing the wall this past weekend with some starboard material, I ordered a new tacklebox from finnaddict marine . [url][/url]

we picked up our anchor at http://www.anchoring.com/stainless-stee ... nchor.html We got our rode at http://www.secosouth.com/mm5/merchant.m ... chor_rodes the SS-22 lb claw is working/looking great on our Gulfstream 23 ! 300' of 8 plat rope,with 30' of chain {330' total length} Were very...

is your trailer being used on a daily basis ? , if not, you could get those trailer tire covers, we bought a set the dual tire covers for both sides. they arent hard to put on even if you do use the trailer daily ,and they do the job.

I'm guessing between 90 -92 for the main, and about 55 for the aux. the book that came with our '93 said 55 for the aux,but that was crossed out,and 90 was hand written in. in the few years we had the boat we haven't needed fill it up to the full capacity. I believe the aux tank is 55 gallons...

when we bought our '93 Gulfstream a few years back, it was either spend a few hundred getting the old leaking seastar kit to work with the new Suzuki 300, or buy a new steering kit. I did a little reading and found the Uflex {ultraflex} Protech 2 kit for $740.00 from the Ebay seller, came with...

I just tried again,and it worked !

I'm trying to figure out how to upload photos into the Gallery. but the upload link in the Gallery takes me somewhere else ? How is this done ? thanks,

Here's our '93 Gulfstream 230

Had to have this installed as drilling such a large hole {this ducer is huge} in the bottom of the boat was something I couldn't handle :mrgreen: Palmer Point Marine,a few marinas over from us did the install,came out great !

on my Gulfstream 230 I have an Airmar SS-264,200 mgz,20 degree {Wide} hooked up to a Furuno FCV-620, and I'm very happy with this setup. We fish the Sound as were docked in Cos Cob CT {Mianus River}, We can read bottom at WOT with this setup ! Even though, the FCV-620 isn't a 1 kw rated...

I like the way that custom panel looks with the Grady Logo. I also like the fact you wouldn't need a starboard backing plate with it ! I Re-did mine last spring with a blue seas panel,and just swapped out some of the standard breakers for the correct ones. I'm happy with it. this pic was taken...

Has anyone replaced the back collapsible wall in front of the splashwell ? Our wall {2 piece bifold wall} is shot and needs to be replaced. I planned on getting (2) 3/4" pieces of white Starboard material and re-use the piano hinges from the deck and mid section,but I'm starting to re-think a...