Have a 1994 GW Tournament 190 and need to replace the anchor locker door. Does anyone have that item or know where I can find one? Thank you
Anchor Locker Door
- Thread starter CDP
- Start date
You might get lucky by googling for marine salvage yards. Other than that, your most likely best course of action is to fix it or rebuild/replicate it.
In the 'worst ' case, you can use the old lid to make a mold for a new hatch. A fiberglass shop could do that.
If you are not too picky, a hatch could be fabricated using Starbioard. The color probably won't match but that approach would be a lot less expensive than having a mold and a lid made.
The old lid may be repairable. Bring it to a fiberglass shop and see what they think.
If you are not too picky, a hatch could be fabricated using Starbioard. The color probably won't match but that approach would be a lot less expensive than having a mold and a lid made.
The old lid may be repairable. Bring it to a fiberglass shop and see what they think.
Hookup1
GreatGrady Captain
- Joined
- Oct 16, 2007
- Messages
- 3,199
- Reaction score
- 910
- Points
- 113
- Age
- 70
- Location
- Cape May, NJ
- Model
- Islander
I blew mine up earlier this year. Tore it up with windlass. To save my Florida trip I made one out of 3/4" plywood and sealed it with a layer of fiberglass cloth and resin. Worked fine.
In the meantime, the plywood coring in the old one is torn up and difficult to remove. It's not repairable for on-the-water use but it will make a good model for a mold. I'm in the process or patching it up. At that point I'll make a new one. Mine is 29 1/8" x 9 3/4". Not sure if GW used different hatch sizes across models.
In the meantime, the plywood coring in the old one is torn up and difficult to remove. It's not repairable for on-the-water use but it will make a good model for a mold. I'm in the process or patching it up. At that point I'll make a new one. Mine is 29 1/8" x 9 3/4". Not sure if GW used different hatch sizes across models.