I just purchased a Fisherman 209. It does not have an installed battery charger and I'd like one since I'll keep it in the water. Where would be the best place to install one?
Battery charger
- Thread starter Harpo
- Start date
I don't mean to sound cheeky but the best place is close to the batteries
. You may not need a built-in charger though. If you get a good charge when at sea and don't use a lot of power when not motoring, good batteries should maintain a reasonable charge for a fairly long time.
On my older 208 hull, I would charge the batteries at the end of the season and disconnect them for winter. In the spring, the batteries would always have enough charge to start the motor.
. You may not need a built-in charger though. If you get a good charge when at sea and don't use a lot of power when not motoring, good batteries should maintain a reasonable charge for a fairly long time.On my older 208 hull, I would charge the batteries at the end of the season and disconnect them for winter. In the spring, the batteries would always have enough charge to start the motor.
Hookup1
GreatGrady Captain
- Joined
- Oct 16, 2007
- Messages
- 3,190
- Reaction score
- 909
- Points
- 113
- Age
- 70
- Location
- Cape May, NJ
- Model
- Islander
A ProMariner ProSport HD 2-bank is $180. You can also install a Noco 2-bank for around $120. Both chargers ship with cables that make it easy to install. Not sure but both may have 120vac power plugs. Mount in a reasonably dry area near the batteries (within cable lengths. Also nice to be able to see front panel for status lights for troubleshooting if you need them. I use both brands on my 4 battery system.
This is on a 215. Marinco plug for your extension cord. The dual battery charger is on the other side of that bulkhead. I put in a NOCO 2X5 amp. Had to extend the chargers leads for the port battery
On mine, there was some plywood glassed in on the back side of that bulkhead so you had something to screw in to. Use short screws
On mine, there was some plywood glassed in on the back side of that bulkhead so you had something to screw in to. Use short screws
Seymour Flatwater
Member
- Joined
- Oct 4, 2024
- Messages
- 18
- Reaction score
- 5
- Points
- 3
- Location
- Upper Left Corner, USA
- Model
- Freedom 235
I think that installed or not depends on how hard it is to get to your batteries. Mine are in the bilge close together under the transom, PIA to get to.
I did the same NOCO charger and plug as Coastboater. Install was easy. Happy so far. I'm curious to see how long it will take to fully recharge a battery at 5A after a day of running the 30 Amp potpuller pulling 35lb shrimp pots 300ft. I'm considering installing a bluetooth battery monitor like the Victron in our motorhome.
Regards, Mike
I did the same NOCO charger and plug as Coastboater. Install was easy. Happy so far. I'm curious to see how long it will take to fully recharge a battery at 5A after a day of running the 30 Amp potpuller pulling 35lb shrimp pots 300ft. I'm considering installing a bluetooth battery monitor like the Victron in our motorhome.
Regards, Mike