LED stern lights keep burning out

MashpeeMan

MashpeeMan

Well-Known Member
Joined
May 2, 2017
Messages
115
Reaction score
31
Points
28
Location
Mashpee, MA
A few years ago I replaced the (incandescent) stern light pole on my 2001 192 with an LED light pole. For some reason these LED's keep burning out. Does anybody have any suggestion, or should I just go back to the incandescent? I even tried replacing the Pergo light base (and everything worked fine for a few minutes until again the latest light burned out). Thanks for any advice!
 
Yep, what Glacierbaze says. I'd check it with the engine running too. LED's are very sensitive to current and voltage and don't like it if they are overpowered for too long. Your engine charging circuit probably jumps the voltage at the light to 14 or 15 volts if it's not regulated.
 
  • Like
Reactions: MashpeeMan
Hi,

FYI: I have a stern pole light that I will sell for 1/2 of retail, if you need it. It came off of my 2018 306 Canyon, when I went to a RADAR post with a light pole.
 
JJF said:
Hi,

FYI: I have a stern pole light that I will sell for 1/2 of retail, if you need it. It came off of my 2018 306 Canyon, when I went to a RADAR post with a light pole.
Click to expand...
Thank you... west marine is allowing me to trade in the burned out LED that I have. Appreciate it though.
 
intermittent connections could be an issue. ensure clean and good contacts in the female end.
 
You must log in or register to reply here.