ocean runner 200 stalls at idle - experience?

dtsherry1

New Member
Joined
Jan 14, 2014
Messages
4
Reaction score
0
Points
0
I have twin Johnson ocean runner 200's on my sailfish. The starboard motor stall consistently at idle but stays running when throttled. My mechanic believed it to be an ignition issue and changed out the power pack and stator but this did not help. I personally think its a fuel flow issue. It stalls on either tank so I don't expect a problem between the tanks and the valve but possible after the valve? I also installed a fuel flow meter and notice that while the port motor needle stays fairly constant while running or idling the starboard motor fluctuates fairly significantly as far as flow. Could this be a flow issue and if so how do I check it and clean it out? Thanks in advance.
 

SmokyMtnGrady

Well-Known Member
Joined
Jul 11, 2009
Messages
2,020
Reaction score
504
Points
113
My old 192 was factory equipped with a 150 ocean runner and it too had these problems. We did all to the motor as well. It would start fine and idle fine cold but after running for 20 minutes or so when we stopped the motor it would give us fits. Since I had a single it was a hazard at a times. We never could solve it so when Yamaha came out with their F 150 we traded the motor in and empowered. Best decision I ever made. B our fuel economy more than doubled and the motor never had a lick of trouble.
 

Lt.Mike

Well-Known Member
Joined
Oct 18, 2013
Messages
879
Reaction score
165
Points
43
Age
64
Location
Farmingdale NJ
Model
Overnighter
What year? Carburetor?
Check to see if the fuel line is sucking air. IE: cracked line, gasket...
 

shauncooper

Well-Known Member
Joined
Jul 14, 2012
Messages
66
Reaction score
0
Points
0
Also check your cylinder compression - I had a '95 OCean Pro 150 exhibiting the same symptoms, ran fine at virtually anything above idle, but cut-out on idle, turned out I had a cylinder with low compression.
 

fishbust

Well-Known Member
Joined
Feb 12, 2013
Messages
214
Reaction score
3
Points
16
Location
Long Island
Wow a power pack and a stator? That must have been costly. I hope you kept the old parts.

Usually lean condition on the older motors will do it, especially if it is sneezing. If carb'd, richen up the idle circuit a little bit and mechanically adjust the idle up a bit also.
 

gradydriver

Well-Known Member
Joined
Sep 8, 2010
Messages
69
Reaction score
0
Points
0
It's the carbs and a fuel flow issue.....yer idle jets are clogged...you can overcome it when you pour on the fuel...it's carburation...NOT electrical.....Stator sheez....time for NEW mechanic..... :-|
 

sfc2113

GreatGrady Captain
Joined
Dec 29, 2008
Messages
410
Reaction score
0
Points
16
Location
Long Beach Island, NJ
yes carb rebuild time and check when the last time the vro pump was rebuild, it runs on engine pulse to deliver fuel. Check vac lines by removing them, and inspect them. My parts were worn a bit, more throttle the better it ran. And it stalled a few min after idle. Pump rebuld kit is onlt 140$ per kit so if your not sure if it has been done in a while, do it anyway. Mine Idles as normal after the rebuild.
 

GreatWhite23

Well-Known Member
Joined
Oct 16, 2013
Messages
135
Reaction score
0
Points
0
Had same issue with 150 ocean runner .As Gradydriver described clogged jets. Ran cheap oil ot any more though. There is a utube that is helpful if you are do it yourself.
 

Marty grady 272

Well-Known Member
Joined
Aug 4, 2009
Messages
152
Reaction score
0
Points
0
Location
Lancaster pa/Ventnor nj
I had a pare of the same motors that would stall all of the time at low rpm's. The olde carb engines had a a cut out for 2 cylinders for fuel savings at idle. I had to have the cylinder cut out wiring removed so that my motors stayed running. I tried increasing the idle speed but that didn't work as well as disconnecting the 2 cylinder electric circuit. I never got pushed up against the pilings by the wind or tide again since the motors ran. I didn't hive a hoot about the fuel savings because I didn't waste much time at idle speed.