I have a 1988 seafarer 228G. And have a leak in the original copper steering line. Question is what size and length would I need to replace these to flexible hoses. Thanks in advance!!
Steering hoses
- Thread starter shadow379
- Start date
Late Again Grady
GreatGrady Captain
- Joined
- Sep 22, 2019
- Messages
- 99
- Reaction score
- 37
- Points
- 18
- Age
- 63
- Location
- Little River, SC
- Website
- www.littleriversportfishing.com
- Model
- Sailfish
If Grady customer service can't help you, give the folks at Boat Steering Solutions, LLC a call. They are some very helpful folks and also a source for the flexible hoses.
boatsteering.com
boatsteering.com
Try looking at the hoses near the ram and at the helm. They may have the length printed on them. You can ask Grady as mentioned but it shouldn't be super hard to estimate a length. You should be able to get an accurate measurement from the ram to the rigging tube aft. Add the length of the rigging tube to the deck by the helm and then add the run from the pump to the rigging tube. That last measurement will probably be the hardest to get. You will probably need to remove a panel and/or deck plates to see how the tubing is routed under the helm.
GWL139
Well-Known Member
- Joined
- Jul 25, 2010
- Messages
- 54
- Reaction score
- 4
- Points
- 8
- Location
- Gloucester Township, NJ
- Website
- www.jerseycapeyachtsales.com
- Model
- Gulfstream
Just go to this link and measure per the instructions. It's not a big deal.
www.seastarsolutions.com
Hose & Tubing
Dometic SeaStar steering hoses are a custom multi-layered composite design, engineered specifically for our systems. They are designed to exceed SAE and ABYC specifications and provide precise steering control not achievable with hydraulic industry standard hoses.
www.seastarsolutions.com
Fishtales
Well-Known Member
- Joined
- Jan 31, 2005
- Messages
- 7,721
- Reaction score
- 1,200
- Points
- 113
I had good luck with these guys when I replaced a hydraulic line (flexible one) that burst.
www.seatechmarineproducts.com
Boat Steering - Hydraulic Boat Steering Parts - SeaStar Steering Hose Kits - Page 1 - Seatech Marine Products, Inc
www.seatechmarineproducts.com
If you match the size of the engine throttle and shift cables, you can’t go wrong. The length is printed on the cable about a foot or 2 from one of the cable ends. (Depending on how they were installed.)