Recent content by lime4x4

Were still using the boat for offshore fishing. I have all the cusshions for the deck and cuddy. And the engines actually still work pretty good yet.. We might decide to just get a camper instead and keep the boat strictly for fishing. Right now we stay on the boat at the marina. That's why were...

The problem was pics were to large. I resized them. The trailer is a tandem with new axles,springs, disk brakes and electric over hydrulic pump. I'm just looking for a rough idea on value. I know the boat is old and the engines are old. At one time i was told my offshore is kinda rare cause it...

I don't know why the other pics didn't upload

Thinking of selling our 1986 grady offshore 24 with twin 1987 yamaha 150 2 stroke outboards. Were getting older and getting in and out of the cuddy isn't easy some times. Were looking to go to a sailfish with the stand up cuddy. So what would be a good asking price for the boat? Both engines...

I'm sure there the original wire yet. I looked at getting new ones but there only part of the coil. They didn't come completely off but i was able to push them 1/4" onto the plugs. Thought about zip tieing them but i'm thinking the zip tie will eventually cut thru the boot. Might just replace...

On a recent outing into the Atlantic Ocean my twin 1986 yamaha 150 outboards didn't sound right plus the power seemed a little off. When we got back to the marinia i removed the engine cowls and found some of the plug wires weren't tight on the sparkplugs. Most likely from taking a slight...

We have a 86 gradywhite 24 offshore which we take out off the coast of Delaware. WE carry a personal epirb with us in the ditch bag. Thinking of getting one that attaches to the boat and automaticly goes off if something were to happen. I started to look at them and i see they have a few...

Found the problem. There are relays inside each control handle assembly. One of the wires slightly pulled out of the connector for the relay for the starboard engine.

I used teleflex cables and transfered the ends from my original cables to the new ones

Working on 1986 gradywhite offshore with twin yamaha 150 outboards with a 704 twin engine binnacles. I just replaced all 4 shift and throttle cables. If i use the trim switch in the port handle the engines will lower but only the port engine will raise. I can get the starboard engine to raise...

Thanks got it apart and cables replaced

I need to replace the shift and throttle cable for my twin engine 1986 yamaha 150 outboards. How do u seperate the 2 halves to get at the cables?

That's not it. After researching it on perko's website that deck fill is designed to screw on to a pipe. But thanks thou

Thanks it's for a 1.5" hose. Never thought of looking at west marine.

I have a 1986 offshore 24. I need to replace the gas deck fill. The problem i'm having is finding one big enough. My original one measures 3.5 inches across the top. Everything i'm finding is between 2 and 2.5 inches.