Recent content by Phil

Hello, I am looking to replace my Norcold fidge in my Marlin. Was told that isotherm 49 would be a fairly simple replacement. Any advice??

I have never done any gelcoat repair, I need to do some touchups for screw holes on the boat. Can anyone recommend a product and how to match the colours? thanks in advance

No I don’t think so. May leave that one up to the pros

Thank you!

Does anyone know how to remove the cockpit cushions/upholstery in a 2001 Marlin? I thought it would be through bolted but it looks like it could potentially be screwed in with no access to the screws

Thank you, there is no port under my table. I have access under the midberth as well as just outside the bathroom door. This as actually the access to my sump as well

Thanks, i have that as well. That must be where the newer models have their access. I also have an access just outside of the bathroom door.

HI All So I am looking to teak and holly my floor of my 2001 Marlin but I have my forward bildge access hatch there. It’s not really an issue, but i noticed that the 2004+ models do not have the access there.... I have attached a picture that I found from the net. Is this the case? If so...

My concern about putting it in and around the interior is the noise from the furnace at night. There is actually quite a bit of space on the aft side of the bulkhead between the fuel tanks and the batteries. I could even put the kerosene tank in that area as well. If need be, i could put a...

Hello there, I am going to install hydronic espar system in my Marlin. Currently, my hot water tank in inoperable but i can still Use it to store hot water. Obviously I’ll be using the system for interior heating as well. I was just wondering if anyone had a recommendation as to where the best...

Hello all I just purchased a 2001 Marlyn 300 and I am looking to replace the stove. From my research it looks as though Grady uses Kenyon cooktops. Has anyone had any experience replacing the stove in a 2001 Grady?

Hello all i am looking to replace the alcohol/ electric stove on my Marlin. Does anyone have any recommendations for an electric replacement? I was just thinking to use the same as the 2006 Marlin model but am unsure if it fits right in. Any advice would be appreciated

Does anyone have a goose source for replacement rocker switches for the dash panel?

I am looking to buy a new steering wheel for my 2001 Marlin 30. You can get one with a 5/8 nut or a 1/2 inch nut. Does anyone know which size fits the Grady steering shaft?

Thanks, understood on ergonomics but the stainless just looks great