Search results

I agree not being able to find 1 with the scupper/flapper........and they're very $$$ (bronze)!! I'm leaning towards replacing the hoses and leaving the thru hull fittings and replacing the flappers.

Looked at my scupper hoses tonight and confirmed my suspicions that they need replacing. Any recommendations for scuppers and where to purchase? Stainless, bronze, plastic, etc....???

Were the scuppers so low you got water on the deck?

The aux fuel tank is fwd of the main.

So it sounds like I should ok............have not pulled the trigger yet.

I checked w/ the insurance and they said no problem

Looks like you and your father are getting ready for spring!! Seems like you already have a good following on here! I wish you guys all the luck in the world!! I'm jealous..........wish I could join in!

I have a '95 268 Islander w/ twin '95 Johnson 175's. They weigh ~375# ea, boat is rated for 400HP Max. Considering a pair us '99 Yamaha ox66 225's. They weigh ~500# ea.......that's an additional 250lbs hanging off the back, no too worried about the additional 50HP.....never ride WOT. The '95 200...

Very interesting.........nicely done! I'm particularly interested in the hardware you used for the railing, locks/hinges. I bow in at my slip w/o floating docks. At high tide I need a ladder to board. Have seen some boats with the front of the bow rail removed but don't care for the look. If I...

Think I have a bad sending unit for the aux fuel tank on my Islander. I have the fresh water tank and it seems as though the aux fuel tank is under the fresh water tank. There's an access port at the stern of the hatch at the helm deck........if that makes sense. There's another access port at...

I removed the fridge last night and didn't see a pump. Will look into removing top step tonight.

Finally getting around to getting the fresh water system on my Islander operational. Added water to the fresh water tank........hit the water pressure switch.......opened the faucet in the cabin sink and water started to come out, closed that faucet and opened the faucet in the head, no water...

Need to replace some of the stripe on my '95 Islander. Any ideas on where to score some? Have seen it on ebay at times.......not at the moment.

I just want to get back on the water!

What is the difference? Are they interchangeable? Deck hatch vs. below waterline through hull opening for transducer install (~1" hole).

The word "this" contains a link...........

Thanks deep.....I am actually replacing a transducer that was already installed, not looking into drilling another hole(s). There are actually 2 transducers in this location w/ both the cables going through the same hole. Guess I'll clean-out the existing hole as best as possible, coat w/ epoxy...

Thanks for the response Dennis. Found this on the WWW this morning..........doesn't seem like its made for transducer sized cables........

Need to replace a transducer on my '95 268 Islander which has the stepped hull. Currently the transducer is mounted on the "vertical" surface which is approximately 24" fwd of the transom. In this configuration the cable for the transducer goes through the hull below the water line. Whoever...