Repower, motor height, and props

A

aassbb

Member
Joined
Jun 18, 2023
Messages
7
Reaction score
0
Points
1
Age
55
Model
Sailfish
Just repowered a 94 Sailfish with new Suzuki 200’s. Ten hours in and performance suggests motors are mounted too low. Very slow hole shot. Have to pin it to get on plane. Won’t hold plane below 4000-4200. Cavitation plate is a few inches below edge of hull, and buried when running on plane.

We’re talking with the shop about raising the motors. I’ve read through posts on here…Should we also consider going to 4 blade props? Now would be the time as we can still turn in the new props.
 
I'm not aware of low engines ever causing hole shot issues - it's more of a top end problem because of the extra drag it creates (which isn't yet an issue at low speeds).

If the anti-ventilation plate is too low, though, yes, that definitely needs to come up. Strange that they were mounted too low to start with. You can't get into prop changes/discussions until you get the motors the right height and do more testing (including WOT).
 
  • Like
Reactions: Sardinia306Canyon
You should first get engine hight right, usually AV plate 1-2 fingers above the lower transom edge.
Once the height is right you can verify how the props work and in case change pitch and in extreme case install a 4 blade.
Changing several things together lead to confusion about what is going on, so start with the most obvious, the engine hight.
Chris
 
Last edited:
You must log in or register to reply here.