Recent content by Grady Again

I had similar oil residue on the bottom of the cavitation plate on my 115 sws after winter storage. I store it in the down position during the winter season. I found that a small amount of oil leaked around the O ring on power tilt rod and ran down the housing. I did not use fogging oil and...

Make sure holes in gasket and flange are properly lined up to tank holes. Mine were not evenly spaced and only a couple would align until I figered it out. :bang

Mount w/o antenna might have been foe LORAN which had whip antenna similar to radio but is now obsolete.

I pulled it as tight as I could and used a white pencil to mark where the snaps go. I did one snap at a time and with that one snapped I marked the spot for the next one. I would pull it as tight as you can because it tends to stretch some over time and wet weather.

EASY. I USED A SCRIBE (ICE PICK) TYPE DEVICE TO PUNCH HOLE, PLACE SNAP INTO HOLE, PLACE BACK OF SNAP ON IT AND MASH END WITH SNAP TOOL, AVAILABE AS A PLIER TYPE OR PUNCH WITH CUP TYPE AVAILABLE AT MARINE OR FABRIC STORE FOR VERY REASONABLE PRICE. :)

Edit postReport this postReply with quote Snap in console cover for 208 by Grady Again » May Thu 06, 2010 2:10 pm I HAVE A 97 208 ADVENTURE ALSO AND ORDERED A HELM COVER FROM A&J CANVAS 2453 STREETS FERRY ROAD VANCEBORO, NC 28586 252-244-1509 THEY HAD THE PATTERN AND THE ORIGINAL GRADY...

I have Costa Del Mar with the grey lens and do not have a problem reading LCD screens unless I turn my head sideways so that the glasses are vertical and not horizontal. I think this is the case with any polarized sunglasses. 8)

Just sent the e-mail. Very easy to do and only takes a minute. I've had enough problems in small motors and outboards with E-10, I can't imagine how bad E-15 is going to be.

I also contacted GW Customer Service for the same information on my 208 and they were quick to respond and told me exactly what I needed to know. I ordered a new sending unit form WEMAUSA and couldn't be happier. :D

Snap in console cover for 208 I HAVE A 97 208 ADVENTURE ALSO AND ORDERED A HELM COVER FROM A&J CANVAS 2453 STREETS FERRY ROAD VANCEBORO, NC 28586 252-244-1509 THEY HAD THE PATTERN AND THE ORIGINAL GRADY BLUE COLOR. THEY SENT THE SNAPS WITH IT AND I HAD TO PUT THEM ON AS SNAP...

I PUT A TEE IN LINE JUST BEFORE RECESSED FAUCET AND HOOKED A KITCHEN SINK SPRAYER INTO IT. ITS ENOUGH TO RINSE OFF WITH AND SPRAYER HAS A LEVER TO ACTIVATE IT.

Sorry, I don't know about the frame, I just copied the info from a previous post. Might give them a call.

Try this-copied from previous post. Suppose to be original mfgr. for GW The supplier is A and J Canvas - here is their contact information 2453 Streets Ferry Rd Vanceboro, NC , 28586-8350 Phone: 252-244-1509 FAX: 252-244-2508 A and J was great - they even still had the original...

Cleaning non skid gelcoat I use Mr. Clean Magic Erasers to clean. You will not believe how easy it is to do and how good a job it does. :lol:

Yamaha Dealer-Eastern Shore, md. Gootee's Marine in Golden Hill, Md (South of Cambridge, Md). See their web site for additional information. Best in this area. :)