Recent content by jdsmith

  1. J

    Is there a Johnson/Evinrude Motor forum website?

    If so, what is it? Thanks
  2. J

    buzzer behind ignition switch sounding

    I am having the same issue on my 2002 150hp V6 Johnson two stroke. The SELOC shop manual pin pointed the cause as a sensor on the port power plant. It even mentioned that if the sensor was bad the buzzer/horn would sound constantly. I, too, had to disconect the wire from the buzzer. PM me at...
  3. J

    Is Grady White ever going to address the scupper issue?

    Having been a member of this forum for a couple of years now I am amazed of how often the "Scuppers below the water line" issue is presented. (Yet another one was mentioned recently) My 204 center console has the same problem. I find it hard to believe that a boat manufacturer with the...
  4. J

    who's looking out for boaters?

    Don't forget that you can get a credit for gas you purchase for your boat. Of the many taxes that comprise the total cost of a gallon of fuel, one is a "Highway Use" tax. I believe the credit is 17 cents a gallon for gas purchased for boat use. I'll probably have the IRS all over my butt now...
  5. J

    How far back do I run my trolling lines?

    Fishing a striper tournament this weekend and need to know how far back to troll my lures. Assuming it is a calm day, and I will be trolling one line on each 15' outrigger and one line off each gunnell, how far back should I put each line? Do I put the longer lines on the outside of the spread...
  6. J

    Water pooling in forward locker drains

    Had the same issue with my '84 204. Took a garden hose and placed in the compartment drain hole turned on the water and then same process from the through-hull fitting. Blew everything out of the tubes. No problem since then.
  7. J

    Usefull Life Of Curtains?

    What would be the expected usefull life of curtains if I install them on my center console that is kept on my trailer away from saltwater elements? The boat is used mainly in saltwater.
  8. J

    What does the small box with a red x in it mean?

    When trying to view pics on some of the posted threads, there sometimes appears a small white box with a red x inside it instead of the pic. From the replies, it appears that others are able to view the pic. Clicking on the box yields no results. Any thoughts/suggestions?
  9. J

    Where to launch/fish for stripers around Kent Island, Md.?

    With the trophy striper season about to begin in Maryland, can anyone tell me where I might target them near the Kent Island (Narrows) area. Also what marina should I launch from? Further, does anyone know where there is a marina in that area that I can store my boat and trailer? Thanks.
  10. J

    204 Fisherman Owners

    I have a 204 CC Fisherman and fish the Middle to Lower Chesapeake and its river systems with 4 adults with no problem at all. Powered by a 150 Johnson. Smooth ride with relative dryness.
  11. J

    PLEASE READ THIS AND RESPOND!!!!!

    Jerry 1984 204 Fisherman CC with single 2001 150 2 cycle Johnson outboard
  12. J

    Floor Coating

    I recently painted my 204 Fisherman CC deck with Interlux paint and added the Interlux powdered non slip agent to the paint itself. Works great. Just follow directions for a proper mix ratio. Good Luck!
  13. J

    Outraged over the new National Saltwater Angler Registery

    CJBROWN, Do you know of any opposition organizations I might join here in the Richmond, Virginia area? ENOUGH IS ENOUGH!
  14. J

    Outraged over the new National Saltwater Angler Registery

    I just happened across an article in the february 2010 issue of Woods and Water (Page 39) and read about this registry. Someone tell me that I am misunderstanding what I just read. A government registry that will cost each and every saltwater angler about $25.00 beginning in 2011. Is this...
  15. J

    Are all TC-W3 oils the same?

    My 2002 150 hp Johnson 2 cycle outboard recommends using a HD25 oil. As an alternate, they recommend an NMMA TC-W3 oil. As the HD25 oil is hard to find in the Richmond area, along with the fact that it costs $ 25-$35 a gallon I am considering using the TC-W3. Johnson/Evinrude, Quicksilver...