Recent content by Tatt00z

Getting ready to screw it down tomorrow. What size screws did you use, all mine are gone, so I have no idea where to start. Did you counter sink the holes? Thanks again. Glen

Yes, mine is 5/8 I ordered 1/2 inch, thats what I measured at the port hole, but they cut the hole for the port cover, then they took another 1/16 off and added a shoulder for the deck to be recessed. So you dremeled the screw holes a little bigger than filled with fiberglass ? No problems...

I pulled the wood from the fiberglass, and it is 5/8 inch, and when it comes to the looks like they routed out a little material on the hole so the indentd from the holes fit flush. If I use 1/2 inch core, wont the floor be 1/16 inch lower than the rest of the floor? Thanks for your resonse, I'd...

Good morning everyone, I purchased and 90 Marlin a few years ago. The previous owner drilled holes in the center deck, Im guessing to keep it secure. I decided to pull it up and redo the wood. The screws just go through the fiberglass and not the wood. So I thought maybe the wood shrank after 32...

I forgot to mention that it had an electric primer, the fuel bowl with the filter is full, I need that Schrader valve adapter piece to come in, so I can get a better idea. Thanks Sparkdog for the suggestions.

Good afternoon friends, when I parked my boat last year 2003 HPDI 250 motors were running flawlessly. When I launched my boat this year, both motors ran fine for 20 minutes or so , then the port motor cut out, like it ran out of gas. Primed it a few minutes, it started back up and ran for a few...

I've found a pic of it on the lower cowling, but their was no part number for it. Might have to look used. Thanks for the response. Glen

Good morning friends, I just pulled my boat out of dry dock and into my new slip. When I got to my boat that morning I noticed grass coming out of the cowling cover where my rubber grommet used to be. Looks like some how I lost the rubber piece sometime last year and a pretty small bird had...

Too small, thank you for looking out for me

I'll measure tonight. Thank you

Greetings friends, I have a 1990 Marlin 28, and while cruising yesterday the port side vent window fell out and shattered. Does anyone have a lead on a used or new replacement? Thanks Glen

I usually never tow my boat, stays in the water til Dec, then I pull it and store it on the marina lot. Same price a year, land or water. This year they started charging 700 extra to keep in yard during winter months. The winch on it now is electric, and totally rusted out when I bought the boat...

Good evening, Any recommendations on a manual winch for a 1990 Marlin 28? Thanks Glen

After reading some post , and checking a few connections, I followed advice from Rodbolt, and jumped the black and black/red wire coming off the remote tank float, the yellow light went to green, and the pump started automatically filled to top line on main tank, cut itself off, and seems to be...

Seems like what I thought fixed the problem actually didn't. I finally got it to fail after running it for a while a 3/4 throttle. As soon as alarm went off, I stopped, pulled the cowling off, and the main oil tank was at the bottom line, yet the remote tank is full. I am able to use the...