Search results

HULL WEIGHT FOR MY 1988 GW SEAFARER WITH A BRACKET AND HARDTOP? ALSO FUEL TANK CAPACITY OF MY SINGLE TANK ( I THINK IT IS 100 GALLONS) ? THANKS AND TIGHT LINES I had wrong year manufactured!

Rain Water enters my bilge while in exposed dry rack storage. How do I know this? Be cause the stern bilge pump kicks on when the boat is lifted up and tilded back with the Fork Lift. And we have been getting a lot of rain on the Georgia Coast! I suspect the anchor locker, the rear seats...

My 1988 Grady 22 Seafarer has a hole in the rail with a set screw to a pennant mast. The factory does not sell them. Anyone know where I can get a replacement ?

Bought a 1988 Grady 22' Seafarer with a 2003 Evinrude Ficht 225 HP in April 2019. Had 49 hours on it and ran and started really good. I put 50 hours on it this past Summer venturing 10-12 miles offshore of Georgia. Had to have rear bilge pump replaced and farmed out that task to my local...

I did it with a little help from my friends. Searched long and hard for a salvageable hardtop off of a Grady White 22' Seafarer and found one. The rear legs were broken off just underneath the point where the two supports are welded. The front feet or landing pads were left on the sunken boat...

I have my new to me 1988 Seafarer 228 for only 3 months and finally getting the electrical problems solved. The boat was repowered with a 2003 Evinrude 225 and all of those electrical systems work fine. Lights, pumps, etc which are controlled by the switch panel are where the problems have...

I am looking for drop in boxes or trays that fit under the aft seats on my 1988 Seafarer 228. Any advice on where to find? approximate dimensions are 11"x 16.5" Depth unknown Thanks