Search results

Would anyone know of a place who could rebuild my Seastar 1 hydraulic helm pump? Thanks ....jim.

Would anyone know of a place who could rebuild my Seastar 1 hydraulic helm pump? Thanks ....jim.

I was wandering how many gallons the gas tank holds and what is the best,most accurate sending unit you can buy. The current sending unit is a Yamaha I have tried to adjust the arm for a more accurate read with no luck.

:hmm Whats the best way to remove the battery on a 1991 225 g tournament. Its at the port side stern just left of the oil tank. do I unhook the oil tank and slide over or remove the fishbox ? This seems like a poor design.

I have a 1991 225g tourniment, the drain plug on the bracket is buggerd up and won't budge. I havent tried heat and a pipe wrench yet just afraid of doing damage to bracket. Am considering drilling it out and tapping the hole. Does anyone know the size of the hole and thread count I would need ...

What's the best way to winterize baitwell, fresh water / saltwater wash down on a 1991 tourniment? I would like to use recreational antifreeze.

Hi everyone, Im planning to move up to a 1991 22' 225g tournament with a closed transom and grady bracket. It has a Yamaha1996 l250txru . Our current boat is a 1998 206 overnighter with 2007 150 2 stroke Yamaha. The tournament has been in fresh water only and is superb. I had a survey of the...

In need of some advice on replacing starboard side floor drain on a 1989 208. Is there acess if I cut out the bottom of the helm seat storage locker ? Or should I cut a hole through the sidewall just above the drainhole.. Any help would be greatly appreaciated..

What's the best way to store a loaded boat traylor over the winter. I am wanting to take pressure off springs and tires. Do I jack up the frame or do I jack up the axles ? Thanks JB...

Hello fellow boaters, I Need to replace the Starboard floor drain and starboard fishbox drain in my 1989 overnighter. Could i gain acess by cutting a hole in the storage area floor under the helm seat ? Any feedback would be greatly appreaciated.. J.B.

Need to replace floor drain on a 89 overnighter. There are two acess plates I can barely reach the floor drain to replace it. This drain is just foward of passanger seat on the port side Any thoughts would be greatly appreaciated..

In the begining season I ran into some ethenol problems ,since then I have drained and dried the tanks replaced water seperator several times. Also checked and drained the filter at the engine filled with fresh fuel and treated with proper additive. Checked all gas related options had mechanic...

Planning to drain fuel tank and add Racor fuel water separators this week. What size separator do I need for 150 yamaha ? 30 gph. 60 gph. 90 gph ? Also the fuel line hose fitting 5/16 or 3/8 ? . Are the fuel tanks foamed in the belly of the boat ? Wanting to replace the tank next year with a...

Just posing this question would you recomend or not ?

Does anyone have feedback on a 2005 yamaha 2 stroke ?

While replacing the transome drain tubes one of the flared end has developed a small crack. I must have cranked too hard. Do you think I should replace it or let it go? The crack is on the outside of the boat and is in the flared end not the inside of tube I used plenty of epoxy and have a good...

Does anyone have contact information or tips to replace the deck plates in my 1989 overnighter? The deck plate at the transome seems to be cracked..

Can someone explain the prosess to replace the through hull,s and scuppers..Thank Jmbadge..

I just purchased my first grady, long overdue. I was looking for some feedback on issues tht there may be conserning the gas tank and structure of the boat. Any feedback is greatly appreaciated. Also is there a gas main shut off valve anywhare on the boat ? Ive looked everywhare and cannot...

Does anyone have feedback about this engine ? yamaha 225 ox66 .