Search results

Any Gulfstream owners have a rod rack on the transom? Thinking this might work well instead of on the hard top. Thoughts?

I recently purchased a 2008 gulfstream. Performance is terrible. I'm pretty sure the motor is too low and I am out of holes to raise it. It's a Yamaha 300hp on a bracket with a 3' setback. Going to hire a aluminum welder to shorten and raise the lip of the bracket. Would appreciate intel on...

I'm interested in a gulfstream that was just repowered with a 300 Yamaha. . The only problem is the boat rides like crap. The motor is too low in the water and bolted all the way up. No room to go higher. The previous owner I think changed the bracket to accommodate a 350 which is a longer...

Hi, I'm buying a 2008 gulfstream . Anything particular to look out for? Putting new power so not concerned with the motor. Not sure if I should have it surveyed. Thanks

Hi, I am very interested in purchasing a 232 Gulfstream. This would be my third Grady. I intend to trailer it. I think I have enough truck to pull it (2014 Tundra 4x4) and would be driving less than a mile to the ramp at the end of my street. My question is how hard would it be to launch...

I have twin 200,s that are both acting up since I got the boat out of storage. They lose rpm,s for a second and then run fine again. Usually happens when the boat slaps down hard or in rough water. Also not able to get past 44000rpms. Any advise would be appreciated. Thanks in advance

anchor on my sailfish needs nudge to start falling is thier an easy solution to fix? Thanks everyone for all the help, the sailfish I just purchased is great but has alot of little issues, much more complicated than the 208 I used to have. Thanks again, MIke

When I shift into neutral engines are sometimes still engaged forward. Is this easy to fix? Thanks in advance, Mike

I tried to pump out my holding tank for the first time and nothing happened. Not sure if I blew a fuse or what. The owners manual says I should have a switch at the helm but there isn't one. Any suggestions would be appreciated

I am going to add second pump in my 272. Looks like I can get at hull easily be removing livewell. Wondering what type of work needs to be done after I drill the hole for thru hull fitting ? glass repair etc. Not sure if the sides are cored and need to be sealed? Thanks for any advise. Mike

I have two questions. On my sailfish the holding tank always shows 3/4 full even after being pumped out? Second question is fresh water pump turns on every 5 minutes or so for a fraction of a second, I assume I have a leak somewhere any suggestions of first place to look? Thanks in advance.

Just purchased 2000 27' sailfish and having problems with FF. I was told to replace tranducer first see if its that before replacing furuno 582. The transducer is a plastic retractable, flush mounted with speed and temp. What's confusing me is the ducer is perpindicular to water, another words...